LOADING IMAGES

Flexiva NetWave™

The Flexiva NetWave™ networkable digital audio system delivers the extensive features, operational flexibility and robust construction needed for standalone operation in both on-air and production studios, while the slim, desktop styling makes it perfect for news booths, voice tracking and portable applications.

Liên hệ

The Flexiva NetWave^™ networkable digital audio system delivers the extensive features, operational flexibility and robust construction needed for standalone operation in both on-air and production studios, while the slim, desktop styling makes it perfect for news booths, voice tracking and portable applications.

While the Flexiva NetWave console is equally suited for on-air, voice tracking and production capabilities in any facility, the full potential is met when it is used as part of a Flexiva VistaMax™ audio network — as demonstrated by its popularity in countless multi-station facilities worldwide. Not only is it a control surface, but it’s also a fully functional console in which both the four program buses and single offline bus have digital and analog outputs.

The Flexiva NetWave system’s analog inputs can be optionally be increased with a 4X-A2D A to D converter. It can also be networked using any Flexiva VistaMax audio management frame to other audio consoles and I/O Edge devices (VMQ+VMXP), adjusting up or down according to facility needs.

Comprehensive logic facilities, “heads-up” metering, and full compatibility with Flexiva VistaMax audio management devices and software are among the many reasons why the Flexiva NetWave console continues to be a popular choice among engineers, programmers, and on-air talent.

All-digital design to enable everything from program mixes to talkback channels
Four program buses and one offline bus, each with digital and analog outputs
Up to six (two standard) simultaneous telco/codec inputs, each supported by a mix-minus output with automatic online/offline switching
Two local external monitor inputs
Three frame sizes for 8-, 16- or 24-input channels
Compact desktop design (Flexiva NetWave-8 footprint is just 20 in. x 21 in.)
One analog, digital and logic I/O connector on each channel
Ability to distribute local sources and mixed outputs to the Flexiva VistaMax network and attach network sources to any fader in the console (with optional network activation)
Dual router option to upgrade dual fader panels and allow dynamic selection of Flexiva VistaMax network sources directly from the console
Ability to add dual fader panels to the Flexiva NetWave-16/12 and 24/18
Heads-up meter assembly with two stereo bar graph meters: one dedicated to Program 1 and a second that is switchable to monitor other busses, digital clock and timer; meters can be set to display average with peak or average only; additional meters optional
Instant visual verification of bus levels with the dual meter display (quad display option kit available for Flexiva NetWave-16/12 and 24/18)
In-line supply (Flexiva NetWave-8 and -16); rackmount supply (Flexiva NetWave-24)
Optional redundant power supply for continuous operation

Specifications and designs are subject to change without notice.

Listed for the basic signal paths, per channel, with 100k ohms load connected to the analog program outputs in a full NetWave-24 frame. 0 dBu = 0.775 volts RMS, regardless of circuit impedance (equal to 0 dBm into 600 ohms). Noise measurements done using a 20 kHz bandwidth (add 1.7 dB for a 30 kHz bandwidth). Total harmonic distortion (THD+N) is measured using a +18 dBu output with a swept signal and a 20 kHz low pass filter. FSD (full scale digital) = +24 dBu.

Analog Line Inputs
Input Impedance	>60 k ohms, balanced
Nominal Input Level	+4 dBu (each input can be independently trimmed by +/-15dB)
Input Headroom	20 dB above nominal input

Analog Outputs
Output Source Impedance	<3 ohms, active balanced
Output Load Impedance	1 k ohms, minimum
Nominal Output Level	+4 dBu
Maximum Output Level	+24 dBu

Digital Inputs and Outputs
Reference Level	20 dB below FSD
Input Level	Each input can be independently trimmed by +/-15dB
Signal Format	AES-3, S/PDIF (input only)

AES-3 Input and Output
Compliance	24-bit sample rate conversion
Digital Reference	Crystal (internal) or VistaMax slave (external) at 48 kHz ±100 ppm
Internal Sample	Rate 48 kHz
Output Sample Rate	48 kHz nominal (each can be set for 44.1 kHz)
Processing Resolution	24-bit fixed with extended precision accumulators
Conversions	A/D:24-bit, Delta-Sigma, 128x oversampling on all digital inputs; D/A: 24-bit; Delta-Sigma, 128x oversampling
Latency	<600 μs; any input to monitor output

Monitor Outputs
Output Source Impedance	<3 ohms, active balanced
Output Load Impedance	1k ohms minimum
Output Level	+4 dBu nominal; +24 dBu maximum

Frequency Response
Input to Program Output	+0.3 dB/-0.1 dB; from 20 Hz to 20 kHz

Dynamic Range
Analog Input to Analog Output	106 dB referenced to FSD; 108 dB “A” weighted to FSD
Analog Input to Digital Output	108 dB referenced to FSD; 110 dB “A” weighted to FSD
Digital Input to Analog Output	108 dB referenced to FSD; 111 dB “A” weighted to FSD
Digital Input to Digital Output	115 dB

Total Harmonic Distortion + Noise
Analog Input to Analog Output	<0.003%; 20 Hz to 20 kHz (<0.002% typical at 1kHz); +18 dBu input, +18 dBu output
Analog Input to Digital Output	<0.0009%; 20 Hz to 20 kHz; +18 dBu input; -6 dB FSD output
Digital Input to Analog Output	<0.003%; 20 Hz to 20 kHz (<0.002% typical at 1kHz); -6 dB FSD input; +18 dBu output
Digital Input to Digital Output	<0.0005%; 20 Hz to 20 kHz; -6 dB FSD input; -6dB FSD output

Crosstalk Isolation
Program-to-Program	-85 dB; 20 Hz to 20 kHz

Stereo Separation
Analog Program Outputs	>90 dB; 20 Hz to 20 kHz

Console Power Requirements
Measured at 120 V AC/60 Hz
NetWave-8	54 W
NetWave-16	99 W
NetWave-24	141 W

Dimensions (H X W X D)
All NetWave consoles	3 in. (76 mm) maximum height above countertop, except for console reflector, 6 in. (152 mm)
Front-to-back depth	21 in. (533 mm)
NetWave-8	20 in. (508 mm) wide
NetWave-16	32.4 in. (823 mm) wide
NetWave-24	45.2 in. (1148 mm) wide
99-1206 (in-line supply for NetWave 8 and 16)	2 x 3.8 x 9.5 in (51 x 97 x 241 mm)
99-1205 (rack mount supply for NetWave 24)	2 RU: 3.5 x 19 x 10 in. (89 x 483 x 254 mm)